Thinking of Transitioning from Arc Source to LED Lighting?
The big difference, of course, between arc source and LED lighting is in the lamp hours. LED sources are essentially forever. Forever in terms of the life of the fixture.
Lighting NewsNew Product Award Winners Honored At WFX In Dallas Winners for New Product Awards 2017 Announced in Dallas Environmental Projection: Getting It Done Without Projectors New Products 2017: At a Glance, Lighting and Media and Communications
Lighting ResourceUsing LED Video Panels as Lighting
VAST Technologies equips massive worship center with 100 Elation Pro Video Series LED displays.
What is an arc source, and why would we want to switch from it to an LED source?
You know what an arc source is; they’re those lamps that have been in your video projectors since like… forever. And if you’re fortunate enough to afford them, they are in your moving light/intelligent fixtures too. You can recognize them when you turn on that projector and for the first seconds no light comes out of the projector, because it first has to “strike” the lamp. And even then, you have to wait for it to come up to full brightness. That’s why some projectors exhibit a countdown timer, before turning on their output image.
The same is true for lighting fixtures that use arc lamps, but they may not be set to automatically strike on power up. They typically are struck one of two ways, based on your user settings. One choice is to strike once they see a valid DMX signal. The other is to wait until you send the right combination of settings over the DMX signal. The latter is done in your console and varies based on the console.
Why does this matter?
Well, every time you strike an arc lamp (also called discharge lamp, or High Intensity Discharge HID) you lose several hours of run time from the life of the lamp. And their life has typically been only about 1,500 to 2,000 hours! For our comparison, we’ll look at the OSRAM Sirius HRI 440W with a rated life of 1,500 hours, which is used in the Martin MAC Axiom Hybrid.
So, if you strike up your fixtures several times a week (once for rehearsal and once for Sunday morning) then you’ve lost about 200 hours in one year of operation. That’s about 13 percent of the lamp’s estimated life in one year! And they cost a few bucks too. For this one, they cost a little more than $300 each. Not too bad if you have only, say, 10 fixtures.
However, if you use your 10 fixtures for two hours of rehearsal and around four hours on Sunday, then you’re hitting that 1,500 hour mark in less than three years. Expending $3,300 after three years or so may not be too bad for you, but there are other factors we need to consider.
As that lamp ages, it gets dimmer and “browner.” This is because the color temperature of the lamp is dropping. Here’s why a change in color temperature matters.
Latest ResourceWorship Facilities Magazine, September-October 2017
The September-October 2017 issue of Worship Facilities Magazine offers a glance at a Granger Community Church, and their recent install of a Lawo audio mixing console system.